疏水閥 蒸汽系統中的凝結水、空氣和二氧化碳氣體盡快排出，同時限度地自動防止蒸汽的泄漏。
工作原理
蒸汽疏水閥,安裝在蒸汽加熱設備與凝結水回水集管之間。開啟時，桶在底部，閥門全開。凝結水進入疏水閥后,流到桶底，充滿閥體，全部浸沒桶體，然后，凝結水通過全開閥門排至回水集管。蒸汽也從桶體底部進入疏水閥，占據桶體內的頂部，產生浮力。桶體慢慢升起，逐漸向閥座方向移動杠桿，直到關閉閥門。空氣和二氧化碳氣體通過桶體的排氣小孔，聚集在疏水閥的頂部。從排氣孔排出的蒸汽，都會因疏水閥的散熱而凝結。當進來的凝結水開始充滿桶體時桶體開始對杠桿產生一個拉力。隨著凝結水位不斷升高，產生的力不斷增加，直到能夠克服壓差，打開閥門。疏水閥閥門開始打開，作用在閥瓣上的壓差就會減小。桶體將迅速下降，使閥門全開。積聚在疏水閥頂部的不凝性氣體先排出，然后凝結水排出。水流從桶體流出時帶動污物一起流出疏水閥。凝結水排放的同時，蒸汽重新開始進入疏水閥，新的一個周期又開始了。
Trap valves steam system condensate, air and carbon dioxide gas emissions as soon as possible, at the same time to maximize the automatic prevention of steam leakage.
Steam traps, installed between steam heating equipment and condensate return headers. Open, the barrel at the bottom, the valve fully open. Condensate into the trap, the flow to the bottom of the bucket, filled with the valve body, all immersed in the barrel, and then, condensate through the fully open valve to the backwater header. Steam also enters the trap from the bottom of the barrel, occupying the top of the barrel and creating buoyancy. Slowly rise the barrel body, and gradually move the lever toward the seat until the valve is completely closed. Air and carbon dioxide gas pass through the barrel vent holes and collect at the top of the trap. The steam exhausted from the vent will condense due to heat dissipation from the trap. When the incoming condensate begins to fill the barrel, the barrel begins to exert a pulling force on the lever. As the condensate level continues to rise, the resulting force increases until it overcomes the pressure differential and opens the valve. Trap valve begins to open, the role of pressure on the valve will be reduced. The barrel will rapidly drop so that the valve is fully open. The non-condensable gas accumulated at the top of the trap is discharged first, and then the condensed water is discharged. When the water flows out of the barrel body, the dirt flows out ofthe trap together. While the condensate is being discharged, steam begins to re-enter the trap and a new cycle begins again
采購中心
